[one-users] VM state is UNKNOWN

[Rolandas Naujikas]

On 2013-06-01 05:07, Dmitri Chebotarov wrote:
> Hello
>
> I'm seeing following interesting behavior :
>
> I've a VM in RUNNING state, everything works OK. Then I issue
> 'shutdown' command from within the running OS (ie. it's a Linux VM
> and I run 'init 0' to shut it down), the VM shuts down OK, but the
> ONE's state changes from RUNNING to UNKNOWN and I cannot start the VM

onevm restart should work to boot again VM.

> anymore. I expected the status to change to SHUTDOWN, which would
> allow me to start the VM later.

OpenNebula cannot guess want you are doing inside of VM.
If you want really shutdown VM and remove it from OpenNebula, you have 
to do that from OpenNebula.

Regards, Rolandas

> I watched 'virsh list -all' on the host while doing it, and status of
> the VM changes from 'running' to 'in shutdown' for about 10-14
> seconds and then VM is removed from the host (I assume by ONE).
>
> Am I missing something? Or is it expected?
>
> ACPI is enabled for the VM and I can send Shutdown signal to the VM
> from the Sunstore interface, which changes the state to SHUTDOWN, but
> not when I run 'shutdown' from within the OK.
>
> Any suggestions?
>
> Thank you. -------------- next part -------------- An HTML attachment
> was scrubbed... URL:
> <http://lists.opennebula.org/pipermail/users-opennebula.org/attachments/20130601/8001e4fc/attachment.html>
>
>
>
>