[one-users] Problem with status

Miloš Kozák milos.kozak at lejmr.com
Mon Aug 19 12:54:50 PDT 2013


Hi,
I have been running an instance of ONE 3.8.3. I have got two main nodes 
providing HA. Today I was updating VNETs .. (adding one new bridge). 
Unfortunately this bridge lies over the management interface. So when I 
changed configuration HA reacted and switched. So far so good. But when 
everything was done I could see that some VMs are in FAILED state. But 
when I checked them with virsh list they were installed and running 
properly.. I let ONE be but after a while all FAILED VMs stayed in 
FAILED state. Worst thing happen when I tried to resubmit them, It let 
the original instance running on the original node and ran a new 
instance on different node. As long as I dont have CLVM and my datastore 
uses shared_lvm it allows to start a VM on multiple hosts at same time.. 
Thankfully I stopped one instance before it could damage FS.

Is there any way how to make hypervisor announce proper state since they 
are running but ONE assumes it is FAILED? Or avoid this situation? I 
find that ONE doesnt update the state upon it finds it in FAILED.

Thanks, Milos


More information about the Users mailing list