[one-users] network configuration

[Jaime Melis]

Hi Liu,

I don't fully understand what the problem is. Why can't you edit
/etc/network/interfaces?

You shouldn't create a bridge in the frontend at all (at least not for
opennebula), the bridge should be created in the nodes. Keep in mind that
even with a bridge your host/node will not lose its IP.

For instance, in the following setup eth0 is the physical interface and
beth0 is a bridge:

# The primary network interface
auto beth0
iface beth0 inet static
        address 192.168.5.10
        netmask 255.255.255.0
        network 192.168.5.0
        broadcast 192.168.5.255
        bridge_ports eth0
        bridge_stp off
        bridge_maxwait 5

As you can see it's configured to bridge the physical interface eth0, so
that VMs can be attached to it by using beth0. Read this document for more
info: https://help.ubuntu.com/community/KVM/Networking .

Regards,

Jaime

On Wed, Oct 21, 2009 at 10:33 AM, Liu, Zhentao <
Zhentao.Liu at fokus-extern.fraunhofer.de> wrote:

>  Hello,
>
> I am new for opennebula. I want to build my cloud with my two PCs. But my
> two PCs are both using static IP addresses in the Ethernet of my institute.
>
> Now I want to configure a bridge on the front-end to assign IP addresses to
> VMs on the node. But I can't configure the file /etc/network/interfaces,
>
> because my network would be down if I configured the file. I only have one
> Ethernet interface eth0. This interface is used to get the static IP address
>
> from my Ethernet. How can I add a bridge  on the front-end to assign IP
> addresses?
>
> Any helps?
>
> Regards
>
> Zhentao
>
> _______________________________________________
> Users mailing list
> Users at lists.opennebula.org
> http://lists.opennebula.org/listinfo.cgi/users-opennebula.org
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.opennebula.org/pipermail/users-opennebula.org/attachments/20091021/694edf47/attachment-0003.htm>